Ranger 2WD V6-245 4.0L VIN X SFI (1997)
INSTALLATION
1. Position the windshield wiper motor and install the three attaching screws. Tighten to 6.8-9.2 Nm (10-14 Lb-Ft).
2. Install ground stud. Tighten to 7-9 Nm (62-80 Lb-In).
3. Install nut and ground strap.
4. Connect wiper motor electrical connector.
5. Install clip completely onto right windshield wiper adapter and connecting arm clip. Make sure the clip is fully seated. Do not put the windshield
wiper adapter and connecting arm clip on the motor crank pin and then try to install the clip.
6. Install the left windshield wiper adapter and connecting arm clip onto the wiper motor crank pin.
7. Install the right windshield wiper adapter and connecting arm clip onto the wiper motor crank pin. Pull the windshield wiper adapter and
connecting arm clip onto the crank pin until it snaps into place. The clip is properly installed if the nib is protruding through the center of the clip.
8. Install the right windshield wiper mounting arm and pivot shaft and nut. Tighten the nut to 10-13 Nm (7-10 Lb-Ft).
