Ranger 2WD V6-3.0L (2008)
Alarm System Transmitter: Service and Repair
PASSIVE ANTI-THEFT SYSTEM (PATS) TRANSCEIVER
Removal and Installation
1. With the ignition lock cylinder in the ON position, press the ignition lock cylinder release button with a suitable tool and pull the ignition lock
cylinder out of the steering column.
2. Remove the steering column opening panel cover and reinforcement.
3. Remove the tilt column handle.
4. Remove the 3 screws and the upper and lower steering column shrouds.
5. Disconnect the electrical connector.
6. Open the 2 clockspring wiring harness guides.
7. Remove the screw and the PATS transceiver.
8. NOTE: Replacement of the PATS transceiver does not require the PATS keys to be programmed into the IC again.
