Ranger 2WD V6-3.0L (2008)
NOTE:
-
The air bag warning indicator illuminates when the restraints control module (RCM) fuse is removed and the ignition switch is ON. This is normal
operation and does not indicate a supplemental restraint system (SRS) fault.
-
The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
1. Remove the 60 percent bench seat.
2. Remove the cup holder and 2 cup holder mounting screws, if equipped.
-
Pull upward and forward to release the cup holder.
3. NOTE: Note the routing of the seat wiring harness for installation.
Detach the wiring harness from the cushion.
-
Disconnect the seat position sensor electrical connector.
-
Detach the wiring harness and electrical connector pin-type retainers.
-
Route out the wiring harness.
4. Remove the nut and safety belt buckle pretensioner.
-
To install, tighten to 40 Nm (30 lb-ft).
5. Release the rear hook-and-loop strip and detach the pin-type retainer.
6. Release the underside hook-and-loop strip and J-clips.
7. Release the rear J-clip below the armrest and position aside the material from around the child safety seat tether anchor.
-
Route out the trim flap through the child safety seat tether anchor.
