Ranger 2WD V6-3.0L (2008)
4. Position the seat cushion foam pad and seat cover down.
5. Position the material around the child safety seat tether anchor and fasten the rear J-clip below the armrest.
-
Route the trim flap through the child safety seat tether anchor.
6. Fasten the J-clips and fasten the underside hook-and-loop strip.
7. Install the pin-type retainer and fasten the rear hook-and-loop strip.
8. Install the safety belt buckle pretensioner and install the nut.
-
Tighten to 40 Nm (30 lb-ft).
9. Route the wiring harness to the cushion.
-
Route the wiring harness.
-
Fasten the wiring harness and electrical connector pin-type retainers.
-
Connect the seat position sensor electrical connector.