Ranger 2WD V6-3.0L (2008)
4. NOTE: If the safety belt guide cover is damaged or if it does not remain closed, install a new cover.
Remove the front belt guide cover.
-
Release the retaining tabs and remove the cover.
5. Remove the bolt and safety belt guide.
-
Use the Safety Belt Bolt Bit to remove the bolt.
-
To install, tighten to 40 Nm (30 lb-ft).
-
Remove the safety belt guide.
6. Remove the safety belt anchor bolt.
-
Use the Safety Belt Bolt Bit to remove the bolt.
-
To install, tighten to 40 Nm (30 lb-ft).
Without center-facing rear seat
7. Remove the C-pillar trim panel floor screws.
