Ranger 2WD V6-3.0L (2008)
8. Release the inboard side rear hook-and-loop strip.
9. Release the inboard side bottom J-clip for access to the safety belt buckle pretensioner.
10. NOTE:
-
Note the routing of the wire harness through the seat for installation.
-
Passenger seat shown, driver seat similar.
Detach the pin-type retainers and safety belt buckle pretensioner wire harness from the seat cushion pan.
-
For driver seat, disconnect the seat position electrical connector.
-
For passenger seat, disconnect the safety belt buckle pretensioner electrical connector.
11. Remove the safety belt buckle pretensioner nut and remove the safety belt buckle pretensioner and wire harness.
12. Remove the outboard rear pin-type retainer and position the material to the side.