Ranger 2WD V6-3.0L (2008)
1
Position the seat back latch release cable.
2
Install the seat back latch release cable end and swivel the cable.
3
Attach the cable at its anchor point.
5. Install the outboard seat backrest latch release cable.
1
Position the cable.
2
Install the seat backrest latch release cable end and swivel the cable.
3
Attach the cable to its anchor point.
6. Position the material and install the outboard pin-type retainer.
7. Install the safety belt buckle pretensioner and install the safety belt buckle pretensioner nut.
-
Tighten to 40 Nm (30 lb-ft).
8. Route the safety belt buckle pretensioner wire harness and install the pin-type retainers.
-
For driver seat, connect the seat position electrical connector.
-
For passenger seat, connect the safety belt buckle pretensioner electrical connector.
