Ranger 2WD V6-3.0L (2008)
3. Position the seat track to the cushion frame assembly and install the 4 bolts.
-
Tighten to 6 Nm (53 lb-in).
4. Attach the cushion trim cover rear J-clip.
Passenger seat
5. Install the seat wiring harness retainer clip and attach the seat wiring harness connector to the seat cushion frame.
All seats
6. Install the seat backrest.
7. Install the seat. If a passenger seat has been serviced, do not prove out the SRS at this time.
Passenger seat
8. WARNING:
-
Install a new occupant classification sensor (OCS) system service kit as a complete assembly. Never install only part of the kit
components. Failure to follow this instruction may result in incorrect operation of the OCS system and increases the risk of serious
personal injury or death in a crash.
-
Make sure the front passenger seat repair is complete, the seat and all attached components (head restraint, seat side shield, etc.) are
correctly assembled, and the seat is correctly installed to the vehicle before carrying out the System Reset. Failure to follow these
instructions may result in incorrect operation of the occupant classification sensor (OCS) system and increases the risk of serious
personal injury or death in a crash.
CAUTION:
-
To prevent system failure, it is necessary to carry out the occupant classification sensor (OCS) system reset when a front passenger
seat cushion is disassembled, a new trim cover installed or an OCS system service kit is installed. A scan tool is used to carry out the
OCS system reset command.
-
To prevent system failure, the following precautions must be taken before carrying out the occupant classification sensor (OCS)
system reset:
-
Make sure the voltage to the occupant classification system module (OCSM) is above 8.0 volts and less than 18.0 volts.
-
Make sure the OCS system is not at a temperature below 6°C (42°F) or above 36°C (97°F) when initiating the OCS system reset
process. If the vehicle has been exposed to extreme cold or hot temperatures, the vehicle must be exposed and kept at a
temperature within the limits, 6°C to 36°C (42°F to 97°F) for a minimum of 30 minutes.
-
Make sure nothing is present on the passenger seat before carrying out the OCS system reset and nothing is placed on the seat
during the process.
-
Make sure a minimum 8-second time period has passed after cycling the ignition switch ON before the carrying out the OCS
system reset process.
NOTE: If the first attempt to carry out the occupant classification sensor (OCS) system reset is unsuccessful, a second attempt must be made. If the
second attempt is unsuccessful, a new OCS system service kit must be installed.
