Ranger 2WD V6-3.0L (2008)
Passenger seat
4. NOTE: Note position of wire routing for installation.
Release the seat wiring harness retainer clip and detach the seat wiring harness connector from the seat cushion frame.
All seats
5. Remove the 4 seat track-to-cushion frame bolts and remove the seat track assembly from the cushion frame.
Driver seat
6. Remove the 2 screws and seat position sensor from the seat track assembly.
All seats
7. NOTE: Note routing of the seat backrest latch release cable through the seat cushion frame.
Detach the pin-type retainer and remove the backrest latch release cable.
8. Release the remaining cushion trim cover J-clips.
-
If driver seat, remove the cushion frame from the foam pad and cushion trim cover.
9. CAUTION: An occupant classification sensor (OCS) system service kit will have the OCS bladder attached to the seat cushion foam pad.
Do not separate the OCS bladder from the seat cushion foam pad. Failure to do so may result in component failure.
Remove all rows of hog rings and remove the cushion trim cover.
