Ranger 2WD V6-3.0L (2008)
All seats
6. CAUTION: Inspect the seat cushion pad and seat cushion trim cover for any foreign objects, before installing the seat cushion trim cover
to the seat cushion pad. If any foreign objects are found, remove them. Failure to follow these instructions may result in incorrect
operation of the occupant classification sensor (OCS) system and may cause system failure.
Position the cushion trim cover to the foam pad and install the hog rings.
7. Install the foam pad and cushion trim cover to the cushion frame and fasten the J-clips.
8. Route the backrest latch release cable through the cushion frame and install the pin-type retainer.
Driver seat
9. Install the seat position sensor and 2 screws to the seat track.
All seats
10. Install the seat track assembly and 4 bolts to the cushion frame.
-
Tighten to 6 Nm (53 lb-in).
Passenger seat
11. Install the seat wiring harness retainer clip and attach the seat wiring harness connector to the seat cushion frame.
