Ranger 2WD V6-3.0L (2008)
NOTE:
-
The air bag warning indicator illuminates when the restraints control module (RCM) fuse is removed and the ignition switch is ON. This is normal
operation and does not indicate a supplemental restraint system (SRS) fault.
-
The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
1. Remove the seat.
2. Remove the 60 percent seat armrest.
3. Remove the 60 percent seat backrest assembly.
4. Remove the seat track assist spring.
5. Remove the seat track adjustment handle.
-
Remove one side of the seat track adjustment handle at a time.
6. Remove the 4 seat track-to-cushion frame bolts and remove the seat track from the seat cushion frame.
7. Remove the 8 rail-to-seat track nuts and separate the seat track rails from the seat track.
Installation
1. Install the seat track rails to the seat track and install the 8 nuts.
-
Tighten to 25 Nm (18 lb-ft).
2. Install the seat track and 4 seat track-to-cushion frame bolts.
-
Tighten to 6 Nm (53 lb-in).
3. Install the seat track adjustment handle.
-
Install one side of the seat track adjustment handle at a time.
4. Install the seat track assist spring.
