Ranger 2WD V6-3.0L (2008)
Wheel Speed Sensor: Service and Repair
Wheel Speed Sensor - Front
Wheel Speed Sensor - Front, Rear Wheel Drive (RWD)
Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Disconnect the wheel speed sensor electrical connector.
3. Remove the wheel speed sensor harness bolt and unclip the retainers.
^
To install, tighten to 12 Nm (9 lb-ft).
4. Remove the wheel speed sensor bolt and the wheel speed sensor.
^
To install, tighten to 12 Nm (9 lb-ft).
5. NOTE: Plug the sensor cavity and thoroughly clean the sensor mounting surface. Apply a light coating of the specified grease to the mounting
surface.
To install, reverse the removal procedure.