Ranger 2WD V6-3.0L (2008)
5. Remove the clutch master cylinder from the brake and clutch pedal bracket by rotating it 45 degrees clockwise.
All vehicles
6. Remove the bulkhead sound insulator.
7. Remove the 2 brake pedal bracket bolts.
^
To install, tighten to 25 Nm (18 lb-ft).
8. CAUTION: Support the brake master cylinder and power brake booster in the engine compartment or damage to components may
occur.
Remove the 4 brake pedal bracket nuts and remove the brake pedal and bracket.
^
To install, tighten to 25 Nm (18 lb-ft).
9. CAUTION: Do not press, pull or otherwise move the brake pedal while installing the stoplamp switch or the speed control deactivator
switch. These switches must be installed with the booster push rod attached to the brake pedal and with the brake pedal in the at-rest
position. Installing these switches with the brake pedal in any other position will result in incorrect adjustment and may damage the
switches.
To install, reverse the removal procedure.