Ranger 2WD V6-3.0L (2008)
Brake Caliper: Service and Repair
Brake Caliper Anchor Plate, Front
Brake Caliper Anchor Plate
NOTE: Rear wheel drive (RWD) shown, four wheel drive (4WD) similar.
Removal and Installation
1. Remove the wheel and tire.
2. Remove the 2 brake caliper guide pin bolts and position the caliper aside.
^
To install, tighten to 36 Nm (27 lb-ft).
^
Support the caliper using mechanic's wire.
3. Remove the brake pads and the brake pad clips.
4. Remove the 2 brake caliper anchor plate bolts and the brake caliper anchor plate.
^
To install, tighten to 115 Nm (85 lb-ft).
5. To install, reverse the removal procedure.
