Ranger 2WD V6-3.0L (2008)
Four Wheel Drive (4WD) Vehicles
Removal
All vehicles
1. Remove the front disc brake caliper anchor plate.
Four wheel drive (4WD) vehicles
2. Remove the brake disc.
Rear wheel drive (RWD) vehicles
3. Remove the hub grease cap.
4. Remove the cotter pin.
5. Remove the hub spindle nut retainer.
6. Remove the hub spindle nut.
7. Remove the outer wheel bearing retaining washer.
8. Remove the outer wheel bearing.
9. Remove the brake disc and hub.
10. NOTE: The wheel hub grease seal is a one-time-use part. When it is removed, a new wheel hub grease seal must be installed.
Remove the wheel hub grease seal.
11. Remove the inner wheel bearing.
Installation
4WD vehicles
1. Install the brake disc.
^
Clean the wheel hub mating surface with brake parts cleaner and apply anti-seize lubricant to the mating surface.