Ranger 2WD V6-3.0L (2008)
4. Open the valve on the bleeder tank.
5. Loosen the RR wheel cylinder bleeder screw. Leave open until clear, bubble-free brake fluid flows, then tighten the RR wheel cylinder bleeder
screw to 8 Nm (71 lb-inch) and remove the rubber hose.
6. Continue bleeding the rest of the system, going in order from the LR wheel cylinder bleeder screw to the RF disc brake caliper bleeder screw,
ending with the LF disc brake caliper bleeder screw.
^
Tighten the brake caliper bleeder screws to 15 Nm (11 lb-ft).
7. Close the bleeder tank valve. Remove the tank hose from the adapter and remove the adapter. Fill the reservoir with clean, specified brake fluid
and install the reservoir cap.
8. Apply brakes several times to verify correct brake operation.
