Ranger 2WD V6-3.0L (2008)
3. CAUTION: Do not pry in the caliper sight hole to retract the pistons as this can damage the pistons and boots.
Remove the 2 brake caliper guide pin bolts and the brake caliper.
^
If leaks or damaged boots are found, install a new disc brake caliper.
Installation
1. CAUTION: Tighten the bottom caliper bolt before tightening the top caliper bolt or damage to guide pins may occur.
CAUTION: Make sure the caliper pin boots are correctly seated to prevent damage to the guide pins.
Position the brake caliper and install the 2 brake caliper guide pin bolts.
^
Tighten to 36 Nm (27 lb-ft).
2. Using 2 new copper washers, position the brake hose and install the brake caliper flow bolt.
^
Tighten to 34 Nm (25 lb-ft).
3. Bleed the brake caliper.
4. Install the wheel and tire.
5. Test the brake system for normal operation.
6. Apply the brakes several times to verify correct brake operation.