Ranger 2WD V6-3.0L (2008)
Wheel Cylinder: Overhaul
Wheel Cylinder
NOTE: Removal is not necessary to disassemble, inspect, hone or overhaul the rear wheel cylinder.
Disassembly and Assembly
WARNING: Do not use any fluid other than clean brake fluid meeting manufacturer's specification. Additionally, do not use brake fluid that
has been previously drained. Following these instructions will help prevent system contamination, brake component damage and the risk of
serious personal injury.
WARNING: Carefully read cautionary information on product label. For EMERGENCY MEDICAL INFORMATION seek medical advice.
In the USA or Canada on Ford/Motorcraft products call: 1-800-959-3673. For additional information, consult the product Material Safety
Data Sheet (MSDS) if available. Failure to follow these instructions may result in serious personal injury.
CAUTION: Brake fluid is harmful to painted and plastic surfaces. If brake fluid is spilled onto a painted or plastic surface, immediately wash
it with water.
1. Remove the wheel cylinder boots.
2. Remove the wheel cylinder pistons.
3. Remove the wheel cylinder cups.
4. Remove the wheel cylinder expander.
5. Remove the wheel cylinder bleeder screw from the rear wheel cylinder.
^
To install, tighten to 8 Nm (71 lb-inch).
6. NOTE: Coat all the wheel cylinder parts with brake fluid.
