Ranger 2WD V6-3.0L (2008)
Parking Brake Cable - Rear
Removal and Installation
1. NOTE: Make sure the parking brake control is fully released.
Release the parking brake cable tension.
2. Remove the brake shoes.
3. Disconnect the RH rear parking brake cable from the intermediate cable at the cable union.
4. Compress the retainer and separate the RH rear parking brake cable from the LH rear parking brake cable at the equalizer.
5. Remove the parking brake cable wireform bracket bolt.
^
To install, tighten to 17 Nm (13 lb-ft).
