Ranger 2WD V6-3.0L (2008)
7. Separate the speed control cable from the intake manifold.
1
Disconnect the cable from the throttle lever.
2
Press the locking tabs and separate the speed control cable from the intake manifold.
All vehicles
8. Remove the speed control cable cap from the speed control actuator.
-
Push in the locking arm on the speed control cable cap then rotate the cap counterclockwise.
9. Remove the speed control cable.
1
Press the spring retainer.
2
Slide the core wire end out of the speed control actuator pulley and remove the speed control cable.
10. NOTE: Make sure the rubber seal is fully seated onto the speed control cable cap.