Ranger 2WD V6-3.0L (2008)
All vehicles
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Remove the hood.
3. Remove the fan blade.
4. Attach the Lifting Eyes.
5. Remove the engine support insulator nuts.
6. Raise the engine and support with a Three-Bar Engine Support Kit.
Rear wheel drive (RWD) vehicles
7. Remove the right front spring.
8. Remove the engine support insulator nut.
Four wheel drive (4WD) vehicles
9. Remove the RH front halfshaft.
10. Remove the engine support insulator nut.
All vehicles
11. Remove the engine support insulator.
Installation
All vehicles
1. Position the engine support insulator.
4WD vehicles
2. Install the engine support insulator nut.
^
Tighten to 103 Nm (76 lb-ft).