Ranger 2WD V6-3.0L (2008)
10. Remove the LH side of the exhaust Y-pipe.
11. Remove the LH side of the exhaust Y-pipe-to-RH side of the exhaust Y-pipe gasket.
^
Discard the gasket.
12. NOTE: 3.0L shown, 4.0L similar.
Remove the RH side of the exhaust Y-pipe-to-exhaust manifold nuts and remove the RH side of the exhaust Y-pipe.
^
Discard the nuts.
Installation
CAUTION: Do not use oil or grease-based lubricants on the isolators. These lubricants may cause deterioration of the rubber. This can lead
to separation of the isolator from the exhaust hanger bracket during vehicle operation.
NOTE: Clean all the mating surface of the exhaust Y-pipe.
1. NOTE: 3.0L shown, 4.0L similar.
Position the RH side of the exhaust Y-pipe into the vehicle and loosely install the new RH side of the exhaust Y-pipe-to-exhaust manifold nuts.
2. Install a new LH side of the exhaust Y-pipe-to-RH side of the exhaust Y-pipe gasket.
3. NOTE: 3.0L shown, 4.0L similar.
