Ranger 2WD V6-3.0L (2008)
Air Door Actuator / Motor: Service and Repair
Vacuum Control Motor - Panel/Floor Door
VACUUM CONTROL MOTOR - PANEL/FLOOR DOOR
Removal and Installation
1. Remove the lower steering column cover.
1
Remove the screws and detach the hood release handle.
2
Remove the 2 screws.
3
Remove the lower steering column cover.
2. Remove the bolts and the lower steering column cover reinforcement.
3. Remove the 2 bolts and the instrument panel support brace.
-
To install, tighten to 9 Nm (80 lb-in).
4. Remove the screws and disconnect the vacuum hose.