Ranger 2WD V6-3.0L (2008)
Housing Assembly HVAC: Service and Repair
Evaporator Core Housing
EVAPORATOR CORE HOUSING
Removal and Installation
NOTE:
-
The evaporator core is not separately serviceable, it is serviced only with the evaporator core housing assembly.
-
If an evaporator core leak is suspected, the evaporator core must be leak tested before it is removed from the vehicle.
-
Installation of a new suction accumulator is not required when repairing the refrigerant system except when there is physical evidence of system
contamination from a failed A/C compressor or damage to the suction accumulator.
All vehicles
1. Drain the cooling system.
2. Recover the refrigerant.
3. Remove the air cleaner outlet pipe.
4. Remove the suction accumulator.
Vehicles with 2.3L engine
5. Remove the A/C compressor.
6. Remove the engine oil indicator and tube.
Vehicles with 3.0L and 4.0L engines
7. Position the coolant reservoir and windshield washer reservoir aside.
1
Remove the 2 screws and 2 nuts.
2
Position the reservoirs aside.
