Ranger 2WD V6-3.0L (2008)
10. Open the glove compartment door fully to access the passenger air bag electrical connector.
11. Release the tab and disconnect the passenger air bag module electrical connector.
12. Attach the restraint system diagnostic tool to the vehicle harness side of the passenger air bag module electrical connector.
13. Install the RCM fuse 8 (10A) to the SJB.
14. Connect the battery ground cable.
Reactivation Procedure
1. Remove the RCM fuse 8 (10A) from the SJB.
2. Disconnect the battery ground cable and wait at least one minute.
3. Remove the restraint system diagnostic tool from the vehicle harness side of the passenger air bag module electrical connector.
4. Connect the passenger air bag module electrical connector.