Ranger 2WD V6-3.0L (2008)
Alignment: Service and Repair
Suspension Design Height Setting
Suspension Design Height Setting
NOTE: Make sure the vehicle is on a flat, level surface, such as a drive-on hoist.
1. Jounce the vehicle's front and rear suspension to normalize the vehicle static ride height.
2. Measure the ride height.
3. NOTE: The torsion bar adjusting bolt is coated with a thread locking compound that wears off after disassembly. If the torsion bar system is ever
disassembled or if the torsion bar adjusting bolt is ever removed, use a new torsion bar adjusting bolt when assembling.
Adjust the ride height as follows:
^
To increase the ride height, tighten the torsion bar adjusting bolt.
^
To decrease the ride height, loosen the torsion bar adjusting bolt.