Ranger 2WD V6-3.0L (2008)
3. Tighten the transmission fluid pan screws in a crisscross sequence.
^
Tighten to 10 Nm (89 lb-inch).
4. If equipped, position the servo heat shield over the servos and clip it to the pan rail.
^
Tighten to 10 Nm (89 lb-inch).
5. Lower the vehicle.
6. NOTE: When filling a dry transmission and converter, start with a minimum of 3.7L (4 qt).
With the engine running and the transmission at normal operating temperature 66-77° C (150-170° F), check and adjust the transmission fluid
level and check for any leaks. If fluid is needed, add fluid in increments of 0.24L (0.5 pt) until the correct level is achieved (fluid should be in the
crosshatched area of the fluid level indicator).
7. Apply the park brake and start the engine.
8. Move the range selector lever through all the gears.
9. Check the transmission fluid level.