Ranger 2WD V6-3.0L (2008)
Hose/Line HVAC: Service and Repair
Compressor Manifold and Tube Assembly
COMPRESSOR MANIFOLD AND TUBE ASSEMBLY
Removal and Installation
NOTE: Installation of a new suction accumulator is not required when repairing the air conditioning system, except when there is physical evidence of
system contamination from a failed A/C compressor or damage to the suction accumulator.
1. Recover the refrigerant.
2. Disconnect the suction accumulator outlet fitting.
-
Discard the O-ring seals.
3. Remove the condenser inlet fitting nut and disconnect the fitting.
-
Discard the O-ring seal.
-
To install, tighten to 8 Nm (71 lb-in).
4. Disconnect the pressure cutoff switch electrical connector.
5. Disconnect the fuel line spring lock coupling.