Ranger 2WD V6-3.0L (2008)
Special Tool(s)
Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Disconnect the catalyst monitor sensor electrical connector.
3. NOTE: If necessary, lubricate the catalyst monitor sensor with lock lubricant to assist in removal.
Using the special tool, remove the catalyst monitor sensor.
-
To install, tighten to 48 Nm (35 lb-ft).
4. NOTE: Apply a light coat of anti-seize lubricant to the threads of the catalyst monitor sensor.
To install, reverse the removal procedure.
