Ranger 2WD V6-3.0L (2008)
4. Close and push the special tool into the open side of the cage.
5. Separate the spring lock coupling.
Connect - Type I
1. NOTE: Apply clean engine oil to the O-ring seals.
Inspect and clean both the spring lock coupling ends. Install new O-ring seals and garter springs if necessary.
2. NOTE: Make sure the fuel tube clicks into place when installing the tube. To make sure that the fuel tube is fully seated, pull on the tube.
Fit the male end into the female end and push until the garter spring snaps over the flared end of the female end.
