Ranger 2WD V6-3.0L (2008)
-
Never probe the electrical connectors on safety belt buckle/retractor pretensioners or adaptive load limiting retractors. Failure to follow this
instruction may result in the accidental deployment of the safety belt pretensioners or adaptive load limiting retractors, which increases the risk of
serious personal injury or death.
CAUTION: It is necessary to carry out the occupant classification sensor (OCS) system reset when a front passenger seat cushion is
disassembled, a new trim cover is installed or an OCS system service kit is installed. A scan tool is used to carry out the OCS system reset
command. Failure to follow this instruction may result in system failure and the incorrect operation of the OCS system.
NOTE:
-
The air bag warning indicator illuminates when the restraints control module (RCM) fuse is removed and the ignition switch is ON. This is normal
operation and does not indicate a supplemental restraint system (SRS) fault.
-
The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
-
Repair is made by installing a new part only. If the new part does not correct the condition, install the original part and carry out the diagnostic
procedure again.
1. Depower the SRS.
2. Remove the 60 percent bench seat.
3. NOTE: Note the routing of the seat wiring harness for installation.
Detach the wiring harness from the cushion.
-
Disconnect the SRS seat position sensor electrical connector.
-
Detach the wiring harness and electrical connector pin-type retainers.
-
Route out the wiring harness.
4. Remove the nut and safety belt buckle pretensioner.
-
To install, tighten to 40 Nm (30 lb-ft).
5. To install, reverse the removal procedure.
6. Install the 60 percent bench seat.
-
Make sure the safety belts and buckles are accessible to the occupants after installation.
7. Repower the SRS.
8. Check the active restraint system for correct operation.
