Ranger 2WD V6-3.0L (2008)
-
For passenger seat, disconnect the safety belt buckle pretensioner electrical connector.
5. Remove the nut, safety belt buckle pretensioner and wire harness.
-
To install, tighten to 40 Nm (30 lb-ft).
6. To install, reverse the removal procedure.
-
Make sure the safety belts and buckles are accessible to the occupants after installation.
7. Install the front seat and repower the SRS. If a passenger seat has been serviced, do not prove out the SRS at this time.
Passenger seat
8. WARNING: Make sure the front passenger seat repair is complete, the seat and all attached components (head restraint, seat side shield,
etc.) are correctly assembled, and the seat is correctly installed to the vehicle before carrying out the System Reset. Failure to follow these
instructions may result in incorrect operation of the occupant classification sensor (OCS) system and increases the risk of serious
personal injury or death in a crash.
CAUTION:
-
The following precautions must be taken before carrying out the occupant classification sensor (OCS) system reset:
-
Make sure the OCS system components are connected and no faults are present.
-
Make sure the voltage to the occupant classification system module (OCSM) is above 8.0 volt and less than 18.0 volts.
-
Make sure the OCS system is not at a temperature below 6°C (42°F) or above 36°C (97°F) when initiating the OCS system reset
process. If the vehicle has been exposed to extreme cold or hot temperatures, the vehicle must be exposed and kept at a
temperature within the limits, 6°C to 36°C (42°C to 97°C) for a minimum of 30 minutes.
-
Make sure nothing is present on the passenger seat before carrying out the OCS system reset and nothing is placed on the seat
during the process.
-
Make sure a minimum 4-second time period has passed after cycling the ignition switch ON before the carrying out the OCS
system reset process.
NOTE: If the first attempt to carry out the occupant classification sensor (OCS) system reset is unsuccessful, a second attempt must be made. If
the second attempt is unsuccessful, a new OCS system service kit must be installed.
Carry out the OCS system reset active command.
All seats
9. NOTE: The ignition switch must be cycled after the OCS system reset.
Prove out the SRS as follows:
Turn the ignition key from ON to OFF. Wait 10 seconds, then turn the key back to ON and visually monitor the air bag warning indicator with the
air bag modules installed. The air bag warning indicator will light continuously for approximately 6 seconds and then turn OFF. If an air bag SRS
fault is present, the air bag warning indicator will:
-
fail to light.
-
remain lit continuously.
-
flash at a 5 Hz rate (RCM not configured).
The air bag warning indicator might not light until approximately 30 seconds after the ignition switch has been turned from the OFF to the ON
position. This is the time required for the RCM to complete the testing of the SRS. If the air bag warning indicator is inoperative and a SRS fault
exists, a chime will sound in a pattern of 5 sets of 5 beeps. If this occurs, the air bag warning indicator and any SRS fault discovered must be
diagnosed and repaired.
Clear all RCM and occupant classification system module (OCSM) DTCs using a scan tool.
