Ranger 2WD V6-3.0L (2008)
2. For SuperCab, remove the front center safety belt buckle bolt cover.
3. Remove the front center safety belt buckle bolt.
-
To install, tighten to 55 Nm (41 lb-ft).
4. NOTE: The SuperCab and regular cab safety belts route differently. Note safety belt buckle position for correct installation.
Route the front center safety belt buckle through the locating strap on the side of the seat cushion and remove.
5. To install, reverse the removal procedure.
6. Check the active restraint system for correct operation.
