Ranger 2WD V6-3.0L (2008)
-
Repair is made by installing a new part only. If the new part does not correct the condition, install the original part and carry out the diagnostic
procedure again.
All vehicles
1. Depower the SRS.
Vehicles equipped with 2.3L and A/C
2. For the RH front impact severity sensor, remove the air cleaner and air cleaner outlet pipe.
All vehicles
3. NOTE:
-
Make sure the radiator support and front impact severity sensor mating surfaces are clean and free of foreign material.
-
Note position of locator tab on sensor bracket for installation.
Remove the front impact severity sensor bolt.
-
To install, tighten to 12 Nm (9 lb-ft).
4. Disconnect the front impact severity sensor electrical connector and remove the sensor.
5. To install, reverse the removal procedure.
6. Repower the SRS.
