Ranger 2WD V6-3.0L (2008)
Battery Cable Generator Connections
Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Disconnect the battery.
3. Remove the bolt and position the battery cable body ground terminal aside.
-
To install, tighten to 12 Nm (9 lb-ft).
4. If equipped, disconnect the A/C cut-off switch connector.
5. Release the 3 battery cable locators from the battery tray and fender.
6. Remove the battery junction box (BJB) cover, remove the 2 nuts and position the BJB terminal aside.
-
To install, tighten to 12 Nm (9 lb-ft).
7. Disconnect the battery cable connector on the fender well.
8. If equipped, disconnect the A/C compressor electrical connector.
9. Remove the 2 battery cable locators from the A/C compressor.
10. Remove the nut and position the battery cable engine bracket aside.
-
To install, tighten to 25 Nm (18 lb-ft).
11. Remove the nut and position the battery cable engine ground terminal aside
-
To install, tighten to 27 Nm (20 lb-ft).
12. Remove the starter solenoid terminal cover.
13. Remove the nut and position the battery cable starter solenoid terminal aside.
-
To install, tighten to 12 Nm (9 lb-ft).