Ranger 2WD V6-3.0L (2008)
Ignition Switch Lock Cylinder: Service and Repair
Ignition Lock Cylinder - Non Functional
IGNITION LOCK CYLINDER - NON FUNCTIONAL
Removal and Installation
1. NOTE: Make sure the front wheels are in the straight-ahead position.
Remove the steering wheel assembly.
2. Twist off the cap from the ignition lock cylinder.
3. NOTE: The lock cylinder is repaired by discarding the inoperative lock cylinder and building a new lock cylinder using the appropriate lock
repair package (F85Z-11582-AA). The lock repair package includes a detailed instruction sheet to build the new lock cylinder to the current key
code of the vehicle.
Remove the ignition lock cylinder.
-
Use a 1/8-inch diameter drill bit to drill out the lock cylinder retaining pin.
-
Use a 3/8-inch drill bit to drill down the middle of the ignition lock key slot until the ignition lock cylinder breaks loose.
-
Remove and discard the ignition lock cylinder and clean the drill shavings from the steering column.
4. Remove the bearing retainer.
5. Remove the bearing and gear.
-
Thoroughly clean all drill shavings from the steering column and inspect it for damage.