Ranger 2WD V6-3.0L (2008)
Removal and Installation
CAUTION: While repairing the power steering system, care should be taken to prevent the entry of foreign material or failure of the power
steering components may result.
1. CAUTION: Do not allow power steering fluid to contact the engine accessory drive belt or the belt may be damaged.
Using a suitable suction device, remove the power steering fluid from the reservoir.
2. Compress the clamp and disconnect the return hose.
3. Compress the clamp and disconnect the power steering pump supply hose.
4. Remove the power steering fluid reservoir nut.
^
To install, tighten to 14 Nm (10 lb-ft).
5. Remove the 2 bolts and the power steering fluid reservoir.
^
To install, tighten to 14 Nm (10 lb-ft).
6. To install, reverse the removal procedure.
7. Fill the power steering system.