Ranger 2WD V6-3.0L (2008)
CAUTION: While repairing the power steering system, care should be taken to prevent the entry of foreign material or failure of the power
steering components may result.
1. CAUTION: Do not allow power steering fluid to contact the engine accessory drive belt or the belt may be damaged.
Using a suitable suction device, remove the power steering fluid from the reservoir.
2. Remove the power steering pump pulley.
3. Disconnect the pressure line-to-pump fitting.
^
Remove and discard the Teflon(R) seal.
^
To install, tighten to 65 Nm (48 lb-ft).
4. Compress the clamp and disconnect the power steering pump supply hose.
5. Remove the 3 bolts and the power steering pump.
^
To install, tighten to 25 Nm (18 lb-ft).
6. CAUTION: A new Teflon(R) seal must be installed any time the pressure line fitting is disconnected from the power steering pump or a
fluid leak may occur.
To install, reverse the removal procedure.
^
Using the special tool, install a new Teflon(R) seal on the pressure line-to-pump fitting.
^
Fill the power steering system.