Ranger 2WD V6-3.0L (2008)
Spindle: Service and Repair
Wheel Spindle
Removal and Installation
CAUTION: Suspension fasteners are critical parts because they affect performance of vital components and systems and their failure may
result in major service expense. New parts must be installed with the same part number or an equivalent part if replacement is necessary. Do
not use a replacement part of lesser quality or substitute design. Torque values must be used as specified during reassembly to make sure of
correct retention of these parts.
1. Remove the brake disc shield.
2. Remove and discard the wheel speed sensor harness bolt.
^
To install, tighten to 12 Nm (9 lb-ft).
3. Remove and discard the wheel speed sensor bolt and disconnect the wheel speed sensor from the wheel spindle.
^
To install, tighten to 12 Nm (9 lb-ft).
4. Remove and discard the outer tie-rod end nut.
