Ranger 2WD V6-3.0L (2008)
Stabilizer Link: Service and Repair
Stabilizer Bar and Link
Stabilizer Bar and Link
Removal and Installation
CAUTION: Suspension fasteners are critical parts because they affect performance of vital components and systems and their failure may
result in major service expense. New parts must be installed with the same part number or an equivalent part if replacement is necessary. Do
not use a replacement part of lesser quality or substitute design. Torque values must be used as specified during reassembly to make sure of
correct retention of these parts.
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Remove and discard the front stabilizer bar link nuts and grommets.
^
To install, tighten to 35 Nm (26 lb-ft).
