Ranger 2WD V6-3.0L (2008)
10. Carefully remove the jack from under the lower arm.
11. Loosen the lower arm bolts and allow the lower arm to swing down.
12. Position the wheel spindle aside and remove the coil spring.
Installation
1. NOTE: The end of the coil spring must cover the first hole and should not be visible in the second hole of the lower arm.
Install the coil spring in the lower arm.
2. Using a suitable jack, support the lower arm.
3. CAUTION: Always install the cotter pin into the lower ball joint nut from outboard to inboard. Failure to do so will result in damage to
the wheel and tire assembly.
Position the lower ball joint and install a new nut.
^
Tighten to 133 Nm (98 lb-ft).
^
Install a new cotter pin.
4. Remove the jack from under the lower control arm.
5. Install the stabilizer bar link assembly in the following sequence.
1
Install the stabilizer bar link stud and grommet.