Ranger 2WD V6-3.0L (2008)
Installation
1. Position the torsion bar into lower arm.
2. Install the torsion bar adjuster in the following sequence.
1
Align the marks on the torsion bar and the torsion bar adjuster, then install the torsion bar adjuster.
2
Position the torsion bar insulator plate.
3. CAUTION: The torsion bar adjustment bolt is coated with dry adhesive and must be replaced if it is backed off or removed. Failure to
do so may cause the adjustment bolt to loosen during operation and cause a loss of vehicle alignment.
Preload the torsion bar in the following sequence.
1
Install the special tool and the adapters.
2
Tighten the special tool until the new adjustment bolt and nut can be installed.
3
Turn the adjustment bolt until the preliminary adjustment measurement (recorded length of the old adjustment bolt) is reached.
