Ranger 2WD V6-3.0L (2008)
3. Place a drain pan under the transmission fluid pan.
4. Drain the transmission fluid.
5. Remove the transmission fluid filter.
1
Remove the transmission fluid filter screw.
2
Remove the transmission fluid filter.
6. NOTE: Main control assembly does not need to be removed for solenoid service.
Remove wire loom guide and protector.
^
Carefully lift up on wire loom guide and protector and disengage the retaining pins from the solenoid clamps.
7. Disconnect the appropriate solenoid electrical connector.
1
Disconnect shift solenoids electrical connectors.
2
Disconnect the torque converter clutch (TCC) solenoid electrical connector.
3
Disconnect the electronic pressure control (EPC) solenoid electrical connector.
8. CAUTION: The torque converter clutch (TCC) solenoid and converter modulator valve may pop out of its bore. This may damage the
solenoid or converter modulator valve.
CAUTION: Shift solenoid (SSC) may pop out of its bore. This may damage the solenoid.