Ranger 2WD V6-3.0L (2008)
3. Remove the 4 rear driveshaft bolts.
4. NOTE: Do not use a hammer.
Remove the rear driveshaft from the flange using a pry bar.
5. Remove the insulator nuts.
6. Raise and support the transmission.
7. Remove the insulator screws.
8. Remove the insulator.
9. Remove the extension housing screws and studs.
10. NOTE: The parking pawl, parking pawl return spring and parking pawl shaft could fall out during removal of the extension housing.
Remove the extension housing. Discard the extension housing gasket.
Installation
1. Clean the extension housing and install a new extension housing gasket. Make sure that the parking pawl, spring and shaft are correctly installed.
2. NOTE: Make sure the parking lever actuating rod is correctly seated into the case parking rod guide cup.
