Ranger 2WD V6-3.0L (2008)
^
Remove all the transmission fluid pan screws except for 2 in the front. Loosen the 2 front transmission fluid pan screws. Pry the rear of the
transmission fluid pan down and allow fluid to drain. After fluid is drained, remove the front 2 transmission fluid pan screws.
8. NOTE: The transmission fluid pan gasket is reusable. Clean and inspect for damage, if not damaged, the gasket should be reused.
Remove the transmission fluid pan.
1
Remove the transmission fluid pan.
2
Remove the transmission fluid pan gasket.
9. Clean and inspect the transmission fluid pan and magnet. Clean all mating surfaces.
10. Remove the manual control valve detent lever spring.
1
Remove the manual control valve detent lever spring screw.
2
Remove the manual control valve detent lever spring.