Ranger 2WD V6-3.0L (2008)
5. CAUTION: Do not bend the manual valve inner lever pin.
Install the manual valve inner lever nut.
^
Tighten to 48 Nm (35 lb-ft).
6. NOTE: Park pawl actuating rod must be correctly installed into parking pawl and guide cup located in extension housing. Verify park linkage
function.
Verify that the output shaft is locked in the PARK position.
7. Rotate the manual lever into the NEUTRAL position and install the manual valve detent spring.
1
Install the spring.
2
Install the screw.
^
Tighten to 10 Nm (89 lb-inch).
8. Position the oil pan magnet in the transmission fluid pan.
