Ranger 2WD V6-3.0L (2008)
Shift Cable: Adjustments
Selector Lever Cable Adjustment
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Place the gearshift lever in the (D) position and hang a 1.4 kg (3 lb) weight on the shift control selector lever.
^
Move the gearshift lever to the first gear position, then move back 2 detents to the (D) position.
^
Hang the 1.4 kg (3 lb) weight on the gearshift lever.
3. Verify the position of the selector lever indicator. If the selector lever indicator does not match the selector lever position the selector lever
indicator will need to be adjusted.
4. Disconnect the transmission selector lever cable from the manual control lever.
5. Remove the selector lever cable clip and remove the cable from the bracket.
6. Place the manual control lever in the (D) position.
1
Rotate the manual control lever fully counterclockwise.
2
Rotate the manual control lever clockwise to the (D) position (2 detents).
7. Install the selector lever cable into the bracket and install the clip.
