Ranger 2WD V6-3.0L (2008)
Selector Lever Cable And Bracket (Part 2)
Removal and Installation
1. Disconnect the transmission selector lever cable from the steering column.
1
Disconnect the selector lever cable from the transmission column shift selector tube.
2
Disconnect the selector lever cable from the steering column bracket.
2. Push the rubber grommet and selector lever cable through the bulkhead.
3. With the vehicle in NEUTRAL, position it on a hoist.
4. Disconnect the selector lever cable from the locking clip.
5. Remove the transmission selector lever cable from the manual lever.
6. Remove the selector lever cable clip and remove the cable from the bracket.