Ranger 2WD V6-3.0L (2008)
3. Remove the 4 rear driveshaft bolts.
4. NOTE: Do not use a hammer.
Remove the rear driveshaft from the flange using a pry bar.
5. Remove the insulator nuts.
6. Raise and support the transmission.
7. Remove the insulator screws.
8. Remove the insulator.
Installation
1. Position the insulator on the extension housing.
2. Install the insulator-to-extension housing screws.
^
Tighten to 90 Nm (66 lb-ft).
3. Install the insulator into the crossmember and tighten the nuts.
^
Tighten to 90 Nm (66 lb-ft).
4. NOTE: Align the driveshaft with the marks made during removal to make sure of correct balance.
Align and install the rear driveshaft.