Ranger 2WD V6-3.0L (2008)
Removal
1. With the vehicle in NEUTRAL, position it on a hoist.
2. NOTE: If equipped, the transmission servo heat shield needs to be unclipped from the fluid pan rail and positioned aside for fluid pan removal.
If equipped, loosen the nut and position the heat shield aside.
3. Drain transmission fluid.
^
Remove all the transmission fluid pan screws except for 2 in the front. Loosen the 2 front transmission fluid pan screws. Pry the rear of the
transmission fluid pan down and allow fluid to drain. After fluid is drained, remove the front 2 transmission fluid pan screws.
4. NOTE: The transmission fluid pan gasket is reusable. Clean and inspect for damage, if not damaged, the gasket should be reused.
Remove the transmission fluid pan.
1
Remove the transmission fluid pan.
2
Remove the transmission fluid pan gasket.